GBoard

KR-TEL0007

New

Gboard is a unique Arduino board which features a SIM900 GSM/GPRS module

3 Items

Ready Stock

Rp 792.000,00

Gboard is a unique Arduino board which features a SIM900 GSM/GPRS module, an XBee socket, nRF24L01+ wireless interface and an ATMega328P controller. This board will add wireless XBee / nRF24L01+ control as well as GSM/GPRS connectivity to your projects. It’s great for anything from home automation to robot control.

 

Overview

Gboard is a unique Arduino board which features a SIM900 GSM/GPRS module, an XBee socket, nRF24L01+ module interface and an ATMega328P controller. This board will add wireless XBee / nRF24L01+ control as well as GSM/GPRS connectivity to your projects. It’s great for anything from home automation to robot control. The possibilities are endless!

Gboard can be used as a GSM/GPRS data transfer or wireless communication project development platform. Gboard support wide range power supply and Micro SD for mass storage. There are some 3pin electronic brick/ sensor brick interface breakout on board, it offer an easy way for a quick prototyping. The board requires FTDI basic board to upload sketch, you can use our Foca board to do it. Gboard can be powered by a mini USB, power Jack.
Hardware


UART Setting Jumpers

The SIM900 module and XBee module communicate to ATMega328 through UART. They cannot be used with the same port at the same time, so there are two UART setting jumpers to configure the UART communication. The figure of UART setting jumpers is as below.

D0 and D1 are hardware UART ports of Arduino. D2 and D3 are digital GPIO of Arduino. There are two configurations to set the UART communication.Description    UART Setting Jumpers Connection
Hardware UART to SIM900,Software UAR to Specific    ST D0(Hardware Rx of Arduino),SR D1(Hardware Tx of Arduino),XT D2(Software Rx/Tx of Arduino),XR D3(Software Rx/Tx of Arduino)
Software UART to SIM900,Hardware UART to Specific    XT D0(Hardware Rx of Arduino),XR D1(Hardware Tx of Arduino),ST D2(Software Rx/Tx of Arduino),SR D3(Software Rx/Tx of Arduino)

Power and reset connection of SIM900

In the GBoard, the PWRKEY and RESET pins of SIM900 module connect to Arduino as list below.Arduino pin    SIM900 pin    Enable
D6    PWR    High level Active
D7    RESET    High level Active

Software

With embedded bootloader, Gboard is easy to use by Arduino IDE through Foca series. ISP of Atmega328 is broke out for download firmware easily.
Note

The GBoard does not have a USB connection. So you need a USB/Serial adapter - we recommend the Foca FT232RL breakout board.

 

Microcontroller      ATMega328P
Max Frequency    16MHz
RAM Capacity       2K
FLASH Capacity   32K
External Resources    Onboard SD socket
Onboard GSM/GPRS
Electronic Brick Interface
Power Supply    External 12V
External 24V
External 7V
External 9V
I/O Operation Level    3.3V
Board Size    89mm x 61mm
Model    IM120411004
Version    1.0
Weight    75.00g
Accessories    Antenna

No customer comments for the moment.

Write a review

GBoard

GBoard

Gboard is a unique Arduino board which features a SIM900 GSM/GPRS module

Related Products

Top