Ultimaker1.5.7 control board supports dual print compatible RAMPS

KR-3D0008

New

Ultimaker1.5.7 control board supports dual print compatible RAMPS

2 Items

Ready Stock

Rp 350.000,00

Features:

This product is an Arduino MEGA as Ultimaker UltiStepper drive is compatible with Pololu stepper driver boards of a board. This is very similar to other electronic -based realization of Pololu including RAMPS, it can support up to five stepper motors ( three as X, one of the other functions Y, Z, an extruder ) . You can add as much as you need stepper drive carriers. It is designed to run at a higher voltage than 12 volts, which allows you to put a 90 -watt MOSFET and run your stepper motor with more torque and higher top speed. It has a head , increasing the SD card module , IDC head added LCD panel ( movie ), PWM output power LED arrays and other lighting and serial I / O , Bluetooth and Ethernet add-ons .

Note : Connect Jumper ( nearly VR tube 7812TV), Arduino MEGA Ultimaker control panel will also have the power.

Simple 4-way JST connector plug for all motors .
Stepper motor control up to 5 ( 3 X, Y and Z axes extruder ( in "E axis" ) , you can optionally add another axis by adding a Pololu stepper drives .
By jumper configuration steps.
3 times 55 amps output MOSFET (with LED indicator. Actual current limited capacity PCB and connector )
All leads are breaking the maximum scalability from 15V to 19V.
Thermocouple input , or thermistor input. 100K thermistor recommendations.
Power on / switch documented board.
Thermocouple wiring easier .
( Normally open ) fan-cooled electronic device includes a 12V regulator.
Now LCD backlight dimming can be controlled by software .

Package Includes 
1x Control board

No customer comments for the moment.

Write a review

Ultimaker1.5.7 control board supports dual print compatible RAMPS

Ultimaker1.5.7 control board supports dual print compatible RAMPS

Ultimaker1.5.7 control board supports dual print compatible RAMPS

Top