Sale!
RAMPS 1.4 - RepRap Arduino Mega Pololu Shield

RAMPS 1.4 - RepRap Arduino Mega Pololu Shield

KR-3D0001

New

It is designed to fit the entire electronics needed for a RepRap in one small package for low cost.

2 Items

Ready Stock

Rp 300.000,00

Specification:
RAMPS is short for RepRap Arduino Mega Pololu Shield. 
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost.
RAMPS interfaces an Arduino Mega/SainSmart Mega with its powerful platform and has plenty room for expansion.
The modular design includes plug in stepper drivers and extruder control electronics on an Arduino Mega/Sainsmart MEGA shield for easy service, part replacement, upgrade-ability and expansion.
Additionally, a number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.

Feature:
Version 1.4 uses surface mount capacitors and resistors to further cover edge issue cases. 
As of version 1.3 in order to fit more stuff RAMPS is no longer designed for easy circuit home etching.
If you want to etch your own PCB either get version 1.25 or Generation_7_Electronics. Version 1.25 and earlier are "1.5 layer" designed boards (i.e. it's double sided board, but one of layers can easily be replaced with wire-jumpers) that is printable on your RepRap with the etch resist pen method, or home fabbed with toner transfer.
Also circuit design supplied initial pin definitions and many design improvements.

Package:
1 x RAMPS 1.4 RepRapp Arduino Mega Pololu Shield For 3D printer Rep

No customer comments for the moment.

Write a review

RAMPS 1.4 - RepRap Arduino Mega Pololu Shield

RAMPS 1.4 - RepRap Arduino Mega Pololu Shield

It is designed to fit the entire electronics needed for a RepRap in one small package for low cost.

Top